Thingiverse
Darts stand
by Steph_Ender
12
Downloads
12
Likes
0
Makes
- 3 DARTS STAND -
As I am a darts player, I wanted to have a funny stand for my darts
you have to glue the pin into the shield. You will need a raft to print the little pin
There is a hole to glue a 8mm magnet at the top of the throwing hand.
2 small holes in the shield that you may have to drill a little to fit your darts.
you can make the shield a little thicker
no Supports needed.
Hope you like it.
Own design, made with Tinkercad except the shield (from the Tinkercad community)
As I am a darts player, I wanted to have a funny stand for my darts
you have to glue the pin into the shield. You will need a raft to print the little pin
There is a hole to glue a 8mm magnet at the top of the throwing hand.
2 small holes in the shield that you may have to drill a little to fit your darts.
you can make the shield a little thicker
no Supports needed.
Hope you like it.
Own design, made with Tinkercad except the shield (from the Tinkercad community)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!