Darwin Mini Robot Display Stand

A display stand for the Robotis Darwin mini robot.

I was fed up of it just lying there, so decided to design a display stand so that it can be put on a shelf without falling off.

The weight distribution is such that the robot centre of gravity is to the front which is why the stand is placed to the rear of the platform. It also allows the robot feet to stay completely within the footprint of the stand.

I have printed this (5 hour print on an Ender 3 Pro at 0.3mm resolution) and it does function ok. However, the top location pegs that the robot sits on are still a little loose for my liking. I started with 3.5mm diameter and ofter the test fit, increased it to 3.9mm presuming a 4mm hole. It seems that this could do with a little more.

If there is enough interest in this thing, I will put some more effort into correcting it, but I'm leaving it as it is for now.
I don't want to waste my time if it's not of use to anyone - the Darwin mini has been arund since 2014 after all, i