Dash Cam Wire Clip

This clip will help keep your wiring for your dash cam very neatly tucked away from view.

In addition to this print you will need:

- adhesive 2 sided roll (might be called "mounting tape" and can be found in the tape aisle)
- scissors or some other type of cutting instrument

Your wiring may or may not be as big as mine is. The dash cam I printed these for uses a Mini USB cable, which is a bit thicker in size than most Micro USB cables. If your dash cam uses Micro USB cabling or any other type that is not the same size as mine, you may want to scale this print down a bit. Fortunately these are quite small and will print very quickly so you can play around with the scaling until you find the right size in a short amount of time and without using too much filament.

I printed these using ABS filament and recommend ABS. I have also tried PLA 2 but the results were not recommended because the heat and direct sunlight in my area caused the PLA clips to warp. If your vehicle will