Thingiverse
Dashcam mount support holder
by copa017
0
Downloads
1
Likes
0
Makes
A mount/support for Apeman C420 dashcams. The fixed windshield angle (23°) suits my Toyota Yaris prefectly (small adjustments could maybe be made after warming with a hair dryer).
I had some similar prints for some years attached successfully with 3M double sided tape (the foamy thing with red protection foil, maybe VHB5609).
It's very easy to print with no support or similar, just lay it down on the front face. I printed with with 0.2mm layer height and 35% infill.
If you want to use/modify the OnShape design (you maybe know that OnShape is free for private usaage) go to this page: https://cad.onshape.com/documents/09a28ba6813dbdd74995005a/w/0911573e85ffc98080479834/e/6f147e349e522d985bff9fcc?renderMode=0&uiState=65aeabfef164bb470dc5a58b
I had some similar prints for some years attached successfully with 3M double sided tape (the foamy thing with red protection foil, maybe VHB5609).
It's very easy to print with no support or similar, just lay it down on the front face. I printed with with 0.2mm layer height and 35% infill.
If you want to use/modify the OnShape design (you maybe know that OnShape is free for private usaage) go to this page: https://cad.onshape.com/documents/09a28ba6813dbdd74995005a/w/0911573e85ffc98080479834/e/6f147e349e522d985bff9fcc?renderMode=0&uiState=65aeabfef164bb470dc5a58b
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
