Thingiverse
davinci-Bernie
von alfagero
0
Downloads
0
Likes
0
Makes
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/5WFygwAahyB
this is a holder for the bernie simple extruder.
fixed on a davinci 1.0a.
You need to drill 3 new holes in the holder(3 mm) for the fixing in davinci.
the two holes for the extruder have to be drilled to 3mm(2 to 3 mm) . At the moment the holes are still manually since it is a first draft . But this is not a problem
.you need 5 m3x20 mm screws an nuts.
this is a holder for the bernie simple extruder.
fixed on a davinci 1.0a.
You need to drill 3 new holes in the holder(3 mm) for the fixing in davinci.
the two holes for the extruder have to be drilled to 3mm(2 to 3 mm) . At the moment the holes are still manually since it is a first draft . But this is not a problem
.you need 5 m3x20 mm screws an nuts.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!