Thingiverse
daVinci catapult remix
por 3Dswsw
5
Descargas
2
Likes
0
Makes
I made a trigger and the drum with a cogwheel to make it easier to use the catapult.
The original spacer is therefore not needed.
The hole for the spoon in the drum is made bigger as the original hole was too small. Two 2 mm holes is drilled into the base.
The trigger is attached with two small woodscrews, one from the top and one from the side at an angle.
The original spacer is therefore not needed.
The hole for the spoon in the drum is made bigger as the original hole was too small. Two 2 mm holes is drilled into the base.
The trigger is attached with two small woodscrews, one from the top and one from the side at an angle.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!