Slicer Discord
Dawn Soap Refill Assistant – 3D-printbaar model van MakerWorld MakerWorld
Other House Models

Dawn Soap Refill Assistant

16 Downloads
21 Likes
12 Makes
Model downloaden
We purchase Dawn refills from Costco, which are in 2.66 L jugs. Those take up too much space on the counter, so we fill them into smaller Dawn 431ml bottles.When there is a bit left in the refill jug, it's hard to get it all out since it drips very slowly.Rather than stand around and try to get it all out, I made a stand where you can place the smaller bottle on the bottom, and the refill on top. You then just let it sit until all the soap empties out of the refill jug.This works also works with the Dawn EZ-Squeeze bottles.May work with other soaps but we mostly use Dawn. How to use:The “assistant” has down arrows on the side. That's the direction of the soap flow, so put the smaller bottle on the bottom. There is a funnel to help guide the soap in. Its optional if you want to use it, but put the funnel in first before you put the bottom jug on.Once it goes on the bottom jug, put the refill on top.Fit is snug as I didn't want it to move while dripping.I only recommend using
Categorie
Other House Models
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie