DBDO E3D Blower Fan mount

I needed a better Airflow solution so i came up with this. This is my second version and im beginning to like it so i thought i would share it.

It is built for my kossel mini but should work with many other printers.
This is my setup! Yours might have to be different... / No guarantees

I have it set up on an Azteeg X5 Mini v1.1. The 30mm Hotend Fan is controlled by a tempswithch configured in Smoothie to go on over or off under 50 degrees Celsius and does not respond to M106 or M107 commands.

The blowers are on the other hand controlled by M106/M107 and use Pin 1.30.

Thanks to these guys for publishing their models on grabCAD
(Models used for visualization only)

bettak@GrabCAD for E3D model
Mitch Pricer@GrabCAD for 30mm fan model
Lehaiver@GrabCAD for Blower Fan model