Slicer Discord
DCC-EX Controller – 3D-Druckmodell von MakerWorld MakerWorld
Other Hobby & DIY

DCC-EX Controller

9 Downloads
5 Likes
4 Makes
Zum Modell
Case for building a hardware DCC-EX Wifi controller (DccEXController of WiTcontroller)Software can be found here: flash62au (Peter Akers) (github.com)This controller can both be used with the WiTcontroller of the DccEXController software. Wiring and configuration can be found on the Github pages.Used hardware:WeMos Lolin lite 4x4 keypadKY040 rotary encoder13x8.25mm switch1.3 inch i2c oled803450 1500Mah Lithium battery2x6mm screwsBeware if the polarity of the batteryleads match the ESP-boards connector!
Kategorie
Other Hobby & DIY
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen