Thingiverse
Dead Blow Hammer
von nrandal
7
Downloads
4
Likes
0
Makes
Head has a cavity that can be filled with your loose aggregate of choice to create a dead blow effect. The striker plate is a separate print so it can be replaced.
Print .2 mm. My holes end up being small on printer so there is a bit of slop added to all bolt holes.
2 M4x12 Hex Bolt - Handle
4 M3x10 Hex Bolt or Button Head - Head Cap
4 M2x8 Button Head - striker plate
The striker plate should be printed either solid or with >40% infill.
Print .2 mm. My holes end up being small on printer so there is a bit of slop added to all bolt holes.
2 M4x12 Hex Bolt - Handle
4 M3x10 Hex Bolt or Button Head - Head Cap
4 M2x8 Button Head - striker plate
The striker plate should be printed either solid or with >40% infill.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
