MakerWorld
Masks & Helmets
Ver Modelo
Deadpool Helmet stand
2.4k
Descargas
1.2k
Likes
937
Makes
Recently printout Deadpool and Wolverine masks and needed a stand. So I put this together.You will need a 3/4 inch wood dowel cut to your preferred length. Plaque - has a notch in it so it can be glued on the base at an angle. You can also glue it facing straight up on the base if you like. I paused the print for the color change on mine.I did use supports on the notch in the plaque. base-bottom.stl - This doesn't need to be printed unless you are gluing the eyes on like I did. It is only 2mm thick so adjust the Z height in your slicer if you need it thicker. Print SettingsPrinter brand: LongerPrinter: Longer LK5 ProRafts: NoSupports: YesResolution: .2Infill: 10Filament brand: EsunFilament color: Ruby RedFilament material: PLANotes: I printed everything but the plaque at .28 to save some time.Plaque was done at .2
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!