MakerWorld
Signs & Logos
Zum Modell
Deadpool Logo Keychain - AMS Not required
122
Downloads
28
Likes
46
Makes
Deadpool Logo Keychain Start with black filamentSwap to Red at Layer 14 (2.8mm)Swap to White at Layer 26 (5.2mm) Make sure you're flushing enough filament when you swap to white – There's only three layers of white so you want to be sure you're getting extruding clean white when you get to the last layer change ----------------If you like my stuff, check out my patreonhttps://www.patreon.com/LilacRage
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
