Death Star USB/Raspberry Pi Hub

This is a Raspberry Pi or USB Hub Modeled after DS1 with a few inspirations for the trenches from similar models. I personally use this as a Raspberry Pi Zero powered Console server at work. The entire model has been built from scratch using Fusion 360, and the files are included if anyone wishes to edit/remix.

Print all the parts as oriented, with supports for the 90 degree overhangs on a few parts. For the USB hubs, I used a few generic 4 port wired hubs from Amazon, and cut away the shells. The grooves on the trench plates should have the metal edges slide in nicely. Secure the 2 trench plates together by snapping them together, or with 3mm screws/bolts if you use the old bolt trench patterns. Place a USB cable in the groove on the Power Plug pieces, and then screw it into the bottom.

For a bit of extra flare, I used a woodburning kit to poke a hole in the dish, and insert a green LED using the "Light Tube" and "Light Tube Cap". You must glue the light tube to line up with the