Thingiverse
Deathly Bard-Hueforge
door Sujirodo
1
Downloads
2
Likes
0
Makes
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 200x200mm in size
Filaments Used:
PLA PolyLite Steel Grey Transmission Distance: 1
PLA Polylite Champagne Transmission Distance: 2
PLA BambuLab Basic Jade White Transmission Distance: 5
PLA Chrominal Shadow Gray Transmission Distance: 3
Swap Instructions:
Start with Steel Grey
At layer #4 (0.4mm) swap to Champagne
At layer #14 (1.2mm) swap to Jade White
At layer #16 (1.36mm) swap to Shadow Gray for the rest.
The Model is 200x200mm in size
Filaments Used:
PLA PolyLite Steel Grey Transmission Distance: 1
PLA Polylite Champagne Transmission Distance: 2
PLA BambuLab Basic Jade White Transmission Distance: 5
PLA Chrominal Shadow Gray Transmission Distance: 3
Swap Instructions:
Start with Steel Grey
At layer #4 (0.4mm) swap to Champagne
At layer #14 (1.2mm) swap to Jade White
At layer #16 (1.36mm) swap to Shadow Gray for the rest.
Sujirodo publiceert ook op
44 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
