Deathly Hallows Smart Light

I made a faithful recreation of the Deathy Hallows emblem that sandwiches a few pieces together to make a decorative light fixture running WLED on a Wemos D1 Mini v3. Yes… it's another birthday present 🤣 You'll need:Black FilamentClear/Natural FilamentWS2812B LEDs (60/m, non-weatherproof!)Wemos D1 Mini v3 (v3 is very important!)2x M2.3x5 self tapping screwsa USB-C Snap-in jackSome Gel CA gluePrinting ConsiderationsI used FilaCube HT-PLA+ Natural for the clear parts, which act as a retainer and diffuser. I printed very slowly (50mm/s) to make them as clear as possible, but perhaps printing faster and getting a foggier effect may be desired. I think the clear helps for light to catch the circle and light it up passively, which is a neat effect. This change is done as a swap-at-layer so only a single filament change is necessary. I also used AnyCubic HS PLA for the black parts, which printed nice and fast. The entire model is built around line widths and layer heights so as to mi