Deathstar Signage

List of hardware needed:Towerpro SG90 servo motorRC servo motor testerLED strip 5vTactile button - 15mm heightTerminal blockBrass threaded insert m3m3 screws - 6mm & 10mmLithium Battery 18650 3.7v - make sure to use 2500mAh or higher battery.. or its not going to be enough to power all servo tester and LEDLithium Battery 18650 holderTP4056 - USB to lithium battery protection & charger moduleRocker switch - 2pins 15x10mmwires.. glue gun.. soldering gun..Wiring diagram:the turrent will be turning using SG90 servo motor..we will be using the servo tester to control the SG90 servo.. there are 3 modes..manual control.. servo centered.. and looping turns…since the servo tester board will be use to control manual movement of the turrent.. we will need to solder a new tactile button to control the modes of the servo tester..everything is powered by a lithium battery connected to a USB charger<img src="https://makerworld.bblmw.com/makerworld/draft/246246/2023-12-08_592094b