Deck Holder Lite

I seen a few 3d prints on here that were very wasteful and took forever to print(i am impatient lol). This is a sleek design with beveled outer edges and a hex design on the bottom to save material.

Sleeves used were Ultrapro, i have heard that Dragonshields are actually a little larger so if anyone wants to test for me that would be great.

The length seems to have a little more play then the width, this was due to improper measuring but i find it works out as it gives room to pull a single card out while still holding the others firmly.

I will be updating this as i go. I will release a open faced one once i print and test it for durability.

ID Dimensions: 67mm x 93mm x 69mm
Wall/Base Thickness: 3mm