Thingiverse
Deck Spindle holder
von LDubya3D
0
Downloads
0
Likes
0
Makes
This is an edit to the original.
I was putting it together and some of the holders broke at the base. Not all but some.
So, I went back and made the base wider and hollow because some of my railings have no space between the top and bottom to fit two 2mm spacers.
100% infill didn't change my times by very much and it feels much stronger.
I was putting it together and some of the holders broke at the base. Not all but some.
So, I went back and made the base wider and hollow because some of my railings have no space between the top and bottom to fit two 2mm spacers.
100% infill didn't change my times by very much and it feels much stronger.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!