Thingiverse
Decorated Firstborn Torso
von Traizork
65
Downloads
56
Likes
0
Makes
Whole torso is made by: https://www.thingiverse.com/cornivius/designs
I only added the decorative ''rope''.
Pressuported. Test printed on Anycubic Photon Mono without issues. The rope detail is about as visible as the wings behind it. May need a little cleanup after removing the supports but I was able to do so just with my fingernails.
The smaller skull (copied from the middle part) is just barely recognisable from a very close distance. Might add simpler variations of it later like a cross or make a flat one.
Scaling is not changed from the original so it should fit.
I only added the decorative ''rope''.
Pressuported. Test printed on Anycubic Photon Mono without issues. The rope detail is about as visible as the wings behind it. May need a little cleanup after removing the supports but I was able to do so just with my fingernails.
The smaller skull (copied from the middle part) is just barely recognisable from a very close distance. Might add simpler variations of it later like a cross or make a flat one.
Scaling is not changed from the original so it should fit.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
