Thingiverse
Decorative Crank
von aelfric5578
3
Downloads
8
Likes
0
Makes
This is a crank designed to fit over a 1/4-inch bolt. It prints in two halves with registration holes that accommodate a small piece of 1.75mm filament for alignment. If glued together, it will spin freely around the bolt.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!