Thingiverse
Deej enclosure
von Broose71
1
Downloads
1
Likes
0
Makes
This is for the Deej slider project. this was designed to have the plates pressure fit into the body without glue or screws.
the lower plate uses 4 brass flange inserts with measurements of M3xL3.5xOD4.6 and they had 3mm LEDs slightly screwed into them to get them to stay.
the knobs on the top I used have a measurement of 30mm x 10mm.
the screen used is a 0.91 inch OLED module
the knobs in the picture were used from https://www.thingiverse.com/thing:4197611 by aithorn
the lower plate uses 4 brass flange inserts with measurements of M3xL3.5xOD4.6 and they had 3mm LEDs slightly screwed into them to get them to stay.
the knobs on the top I used have a measurement of 30mm x 10mm.
the screen used is a 0.91 inch OLED module
the knobs in the picture were used from https://www.thingiverse.com/thing:4197611 by aithorn
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
