Defcon 29 Badge Case

Defcon 29 badges have programmable keys. This makes a great little macro deck so I went ahead and designed a case for it.

The case is snap fit.

The filament I used (Prusament Galaxy Black) has a very low tolerance. If you are using a filament with more shrinkage you might need to scale to account for it.

I did incorporate some slight tolerances.
I did have to cut the top and bottom half into 2 within Prusa slicer. I separated them in Fusion so it was very easy. Flip the top half to print flat side down.

Prusa Mini+
.2
20% infill though 15% should be more than adequate
I did have an issue with the 2mm skirt so I upped that to 8 which worked great