Defiant-class Warship

This is the Defiant-Class Warship (destroyer) for the United States Navy. Below are the instructions. This is printed as a whole, and if printed correctly, may float upright.

First off, supports are highly recommended, as doing so will allow the radar area at the top. I suggest using support line distance of 4mm or less.

Make the bottom at least 30 percent infill. This next part is optional but you can make the top part at 0.5 percent infill if you're anxious like me. The main body can be anywhere between 4 percent to 7 percent.

For extra detail, put a filament change from red to grey at any later between 14 and 21.