Thingiverse
DELISTED - Cable Tie Mount
von Unknown
21
Downloads
20
Likes
0
Makes
Cable tie mount: 20mm x 20mm x 6.6mm
Cable tie openings are 5mm x 2.2mm. Top hole is 5mm x 5mm.
Printed in PLA, .2mm layer height, 2 shells. Use adhesive tape on the back.
Cable tie openings are 5mm x 2.2mm. Top hole is 5mm x 5mm.
Printed in PLA, .2mm layer height, 2 shells. Use adhesive tape on the back.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
