Slicer Discord
Dell Docking Station USB-C Guard – 3D-printbaar model van MakerWorld MakerWorld
Electronics

Dell Docking Station USB-C Guard

243 Downloads
33 Likes
170 Makes
Model downloaden
The guard that goes around the USB-C connector on my Dell WD15 Docking Station broke. This is a perfect fit to replace it. The print profile uploaded uses a 0.12mm layer height which is what I found to be the best. I chose to print the models individually as well so that if one messes up, you can just remove the one that didn't fail and reprint the failed one. The two pieces should snap together with a snug fit. I also chose to use a dab of glue to hold the two together but I just wanted to make sure it never came off. Please feel free to reach out with any suggestions or issues that you have seen with the model or print profile. Happy printing!
Categorie
Electronics
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Waarom?
0.12mm lagen
Eendelig
Supports 1/3
Montage 0/3
Instellingen 2/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Laaghoogte
0.12 mm
Nabewerking
Lijmen
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie