Delta IV Heavy

This is a model of the Delta 4 Heavy that I made. Stands almost a foot tall. The model will stand on its own once put together, but I also made a simulated launch pad with mounts to help keep it steady. The second stage easily slides out and is really only held in place by gravity.
I did a little spray paint job on the model just for kicks!

The model does require a little bit of supports. Print vertically, which ever end does not matter. I printed mine with engines and nose cone up.I printed mine using
0.2mm layer height
20% infill
But I think this model will do just fine with a thicker layer height or less infill

The mounts on the launch pad are a bit fragile and break easily, so be careful once printed.

Assembly instructions -
1) Print 3 engine sections, 2 booster tops, 1 core top, 1 second stage, and 4 longerons.
2) The engines should fit snug to the core and booster tops. I did not have to use any glue
3) Lay the boosters and core together on a flat surface. GLUE