Thingiverse
Delta Kossel Endstop Adjustable
por reganou812
0
Descargas
2
Likes
0
Makes
Adjusting the Z axis end stop position on my Anycubic Kossel Delta print was not very accurate with the factory micro switch bracket.
This bracket has a 6mm bolt to fine tune the end stop position.
Just loosen the T bolt, lower the bracket and then turn the 6mm bolt in or out.
Raise the bracket back up to the top of the rail and tighten.
This bracket has a 6mm bolt to fine tune the end stop position.
Just loosen the T bolt, lower the bracket and then turn the 6mm bolt in or out.
Raise the bracket back up to the top of the rail and tighten.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!