Deltaprintr Extruder Upper Block

Extruder upper Block for Deltaprintr.

This block replaces the original wooden upper part of the extruder on the Deltaprintr.

You may have to drill the holes with a 3mm drill so the filament and the screws fit.
But don't drill the lower hole where the Pulley goes into. If you don't drill all the way down the screw will hold better in place.


Please use the alternative Version if you want to use the original screw.

Important: please be sure you'll drill the screw that goes into the Extruder-Motor as straight as possible.
Otherwise the printed part won't lay flat on the wooden-Extruder-mount