Deltaprintr Lcd Support

After aseembling my deltaprintr, http://deltaprintr.com/#1441834398557-99c3b227-e55e. I noticed there was some flex and give when i pushed down on the click wheel to make a selection. I used fusion360 to draw this support piece to shore everything up. My design is of the front piece only. I used these side pieces off thingiverse to add additional support. http://www.thingiverse.com/thing:1100818. to install gently lift up your printer and slide under the lcd and line up. If the support moves toward you when push down on the lcd the piece needs to be pushed back further. Part prints with flat side down on print bed.