Demigh0d CoreXY Printer

This is my (first) custom built CoreXY printer.

___________
Specifications
==========

* Frame: 2020 aluminum profile
_(20x20 and 20x40, European Standard, V-Slot)_

* Controller: DuetWifi + Duex5
_(www.duet3d.com)_

* Hot End: Kraken
_(4-nozzle, liquid-cooled)_

* Linear Rails: MGN12 rails with MGN12H bearing blocks

* Stepper Motors: 42BYGH
_(4 lead Nema17)_

* Lead Screws: T8

* Bed Connection: KD516 magnetic ball joint
_(permits independent movement of the three Z motors without binding)_

* Build Volume (x,y,z): 330mm x 376mm x 335mm _(13" x 14.8" x 13.19")_

* Outside Dimensions (x,y,z): 559mm x 559mm x 711mm _(22" x 22" x 28")_

__________
notes
=====

* Belt clamp
there are two horizontal holes. You can put two M3x45 screws/washers/bolts in these to reinforce the clamp.
To hold the belts, loop them in the holder and insert a M5 screw. Nut/Washer is not needed.

* Rear bed bracket
Same as the other two brackets. Just attac