Demon Skull

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 200x200mm in size. You can change X and Y but Z must remain the same.You may print at higher layer heights below the Min Depth of 0.48mmActual Depth is 2.2mm Filaments Used:PLA BambuLab Basic Red Transmission Distance: 4PLA BambuLab Basic Orange Transmission Distance: 5PLA BambuLab Basic Jade White Transmission Distance: 5PLA PolyLite Black Transmission Distance: 0.3PLA BambuLab Basic Blue Gray Transmission Distance: 3PLA BambuLab Basic Brown Transmission Distance: 2PLA PolyLite Grey Transmission Distance: 1This print uses 7 unique filaments. Substitute as needed. Swap Instructions:Start with RedAt layer #8 (0.72mm) swap to OrangeAt layer #11 (0.96mm) swap to Jade WhiteAt layer #12 (1.04mm) swap to BlackAt layer #17 (1.44mm) swap to Blue GrayAt layer #21 (1.76mm) swap to BrownAt layer #22 (1.84mm) swap to GreyAt layer #24 (2mm) swap to Jade White for the rest.Boost MeGot a Boost to spare? Every