MakerWorld
Garden
Go to Model
Demons Head Planter
0
Downloads
2
Likes
0
Makes
This was a fun project to create a demon head as a planter, perhaps for spider plants or cacti, as this is a pretty large print, but with a small area for planting. This is more about looks than practical effect. When printed on my H2D, as shown with the supports, the width of the planting hole is approximately 2.4 x 2 inches, and took nearly 16 hours with PETG, as the version without the flat base stand.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
