Slicer Discord
Deodorant Stand – 3D-Druckmodell von Thingiverse Thingiverse

Deodorant Stand

von sandbk
22 Downloads
15 Likes
0 Makes
Zum Modell
This stand stops my deodorant stick from falling over and making a mess of the medicine cabinet.

I find that stick deodorants are always falling over. To make matters worse, the deodorant stick gets increasingly unstable as you use it since the center of gravity moves further and further up; so it falls over more and more. Enough! This stand will finally give your deodorant stick a stable home.

One of the principles of 5S is "seiton" or, roughly, "set in order." This stand makes a place for your stick deodorant.

This stand was made for an Old Spice stick, but will accommodate a stick deodorant of elliptical cross-section that is less than 2.68" wide by 1.35" thick. I printed it at 50% infill to give it mass. If you'll tape it in place, I'd print it at 20% infill.
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen