Desiccant dehumidifier

This is a chamber for desiccant packets that has louvers at each end. There are mounting holes at 105mm for a GDSTIME 120mm fan. The fan is connected to an Inkbird humidity controller. When the humidity gets above a set point then the fan is turned on and the air flow pushes the louvers open. Once the humidity drops to the set point the fan stops and the louvers shut once the flow of air stops.

I am using it in a dry aging chamber that made. It can also be used in a curing chamber.

You need a total of 10 flaps (louvers) the bottom flap can be trimmed a bit to allow it to close a bit more and make a better seal. I cut mine in my slicing software.

Printed using Bambu X1
Basic PLA
Default Settings