Thingiverse
Desk Battery mount
von Gunsling
7
Downloads
1
Likes
0
Makes
I had designed and made this https://www.thingiverse.com/thing:4813000 for my new Xbox wireless headphones. I have very little desk space as I am moving so I thought and designed a desk mount battery holder inspired by https://www.thingiverse.com/thing:872226.
The included STL is 2mm higher than the one in the photo, After printing it can only hold 7 AA dry batteries I figure another 2mm will hold and even 8.
Future change I will tilt it forward a little or sweep the bottom part so the batteries move forward a little nicer.
Approx print time 3 and a half hours 50mm/sec.(just the battery part)
The included STL is 2mm higher than the one in the photo, After printing it can only hold 7 AA dry batteries I figure another 2mm will hold and even 8.
Future change I will tilt it forward a little or sweep the bottom part so the batteries move forward a little nicer.
Approx print time 3 and a half hours 50mm/sec.(just the battery part)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
