Thingiverse
Desk Caddy
von the3Dbunny
14
Downloads
12
Likes
0
Makes
# Desk Caddy by 3DBunny
A desk caddy I made for myself, specific to the pens/highlighters I use. I realize this might not work for everyone, but thought I'd share anyway.
When printed at 100%, the dimensions are 150mm x 82mm x 50mm (L x W x H).
### Holds:
* 9 pens/pencils (diameter of each: 10mm)
* 6 highlighters (highlighter size: 15mm by 25mm)
* 2 post-it note pads (standard size)
* Small space for random things (USB keys, chapstick, airpods, paper clips, SD cards, etc)
### Print Settings:
* Whatever layer height you want
* Infill as low as 5% works
* Use a raft/brim if you're worried about the corners lifting
* No supports needed
A desk caddy I made for myself, specific to the pens/highlighters I use. I realize this might not work for everyone, but thought I'd share anyway.
When printed at 100%, the dimensions are 150mm x 82mm x 50mm (L x W x H).
### Holds:
* 9 pens/pencils (diameter of each: 10mm)
* 6 highlighters (highlighter size: 15mm by 25mm)
* 2 post-it note pads (standard size)
* Small space for random things (USB keys, chapstick, airpods, paper clips, SD cards, etc)
### Print Settings:
* Whatever layer height you want
* Infill as low as 5% works
* Use a raft/brim if you're worried about the corners lifting
* No supports needed
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
