Thingiverse
Desk Clipped Mousepad
by heliometrix
6
Downloads
7
Likes
0
Makes
This is a mousepad holder inspired by the old XFX Warpad. Intended to have a mousepad epoxied to it, should create a 14x14 useable area out of a 14x17 mousepad. print on its side with supports, at 100% infill. Should ideally be printed in a Nylon PA-12 based filament, but could work well with abs or PETG. YMMV if you try PLA due to its stiffness. Designed to clamp on to a 1.5 inch thick desk.
EDIT- Added a V2 STL that is scaled and rotated correctly. Darn you F360 and your native mm exports!
EDIT- Added a V2 STL that is scaled and rotated correctly. Darn you F360 and your native mm exports!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
