Desk Drawer - Gridfinity Compatible

**Desk Drawer -** _**Gridfinity compatible**_
---------------------------------------------

I had some bearings hanging around and needed a new desk drawer so I came up with this desk drawer design, which is compatible with the Gridfinity system by Zack Freedman.

**What size grid fits?**

The drawer fits a 4x5 grid and can handle 7units tall (52.8mm tall bin)

**Instructions:**
-----------------

**You will need:**

1. 8 x (8x22x7 bearings)

2. Glue (not mandatory)


**Print the following:**

1. 2 x Rails.

2. 2 x Slide pins

3. 8 x Bearing pins (print less if you arent using 8 bearings.)

4. 8 x Bearing retainers

5. 2 x Spacer guide


**Assembly:**

1. Place the bearing pins into the rails

2. Place the bearings on the bearing pins

3. Install the bearing retainers over the bearings. It should be a friction fit onto the bearing retainers. However, you may want to put a dab of glue to hold them toget