Desk Garden

UPdated to V2 as I had to tweak the camber on the edges as was causing failed prints.

This is a simpe desk organiser with a compartment at the rear for planting grass or another plant to bring nature to your desk! There is also a side compartment that could fit a small succulent..or some paper clips..its up to you! The front face of the organiser will hold a phone of any size in portrait at a nice viewing angle, and works quite well for landscape too although around 33% of your phone will be 'hanging off' but very stable regardless.

This is my first design project using Fusion 360 and so perhaps isnt the most optimised in tems of plastic used. With a 5% infil (all that is needed) I was using around 130g of PLA.

No need to print with supports.