Thingiverse
Desk Headset Holder
2
Descargas
1
Likes
0
Makes
A simple headset holder as I wanted to utilise some space off my desk and what better than a holder to hang over the edge!
I made this wayyyyy too thick, so I'd recommend to scale it down. Each "bar" is 5mm thick, on the plus side is it is solid AF but it also took 4.5hours to print.
Make sure you print this flat i.e. rotate and drop it down in your slicing software.
I measured this to fit exactly an IKEA desk with the desk-top thickness of 16.6mm.
I made this wayyyyy too thick, so I'd recommend to scale it down. Each "bar" is 5mm thick, on the plus side is it is solid AF but it also took 4.5hours to print.
Make sure you print this flat i.e. rotate and drop it down in your slicing software.
I measured this to fit exactly an IKEA desk with the desk-top thickness of 16.6mm.
EngineeringWithLui también publica en
20 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
