Thingiverse
Desk Hugger V3 (customizable / parametric)
10
Download
8
Likes
0
Makes
This is an update of the DeskHugger cable organizer with a few small tweaks I made.
The code has been updated and commented. I am just learning how to use OpenSCAD, so I figured this was a nice learning opportunity and wanted to document the creation process so that others could better understand the code.
Practically there are two small tweaks made to the DeskHugger v2 design. First, I noticed that when you change the angle of the top bracket, a little outcropping was created from rotating the square. That has been fixed. Second, the alignment for taking the difference of the bottom semi-circle was a bit off and also created a small artifact in the object. That has also been fixed. There are also some minor changes to the parameterization in OpenSCAD to clean up the variable names and available values for them.
The code has been updated and commented. I am just learning how to use OpenSCAD, so I figured this was a nice learning opportunity and wanted to document the creation process so that others could better understand the code.
Practically there are two small tweaks made to the DeskHugger v2 design. First, I noticed that when you change the angle of the top bracket, a little outcropping was created from rotating the square. That has been fixed. Second, the alignment for taking the difference of the bottom semi-circle was a bit off and also created a small artifact in the object. That has also been fixed. There are also some minor changes to the parameterization in OpenSCAD to clean up the variable names and available values for them.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
