Thingiverse
Desk standing lamp
by M4D4O
18
Downloads
16
Likes
0
Makes
Parts needed:
*E14 lamp base with M10x1 thread
*Cable with switch, and plug
Lampshade prints in vase mode with 1mm bottom thickness, and needs to be glued to the lampshade ring (use transparent superglue).
WARNINGS:
Be carefull not to use too strong light bulb, cause too much heat may deform the lampshade. CRI min. 90 LED bulb recommended, 25W halogen also works fine.
Risk of electric shock - be crefull with connecting electrical parst.
*E14 lamp base with M10x1 thread
*Cable with switch, and plug
Lampshade prints in vase mode with 1mm bottom thickness, and needs to be glued to the lampshade ring (use transparent superglue).
WARNINGS:
Be carefull not to use too strong light bulb, cause too much heat may deform the lampshade. CRI min. 90 LED bulb recommended, 25W halogen also works fine.
Risk of electric shock - be crefull with connecting electrical parst.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
