Desk Trashcan

A little trashcan for your desk that you could use for your 3d printing scraps, snack wrappers, and more. It has a swinging lid that makes it easy to use and really easy to empty! You can just flip it over and the lid wont get in the way. The design is simple but functional. I hope you enjoy it!

Height: 25cm
Width: 9cm

!!!Make sure your printer can print 25cm or over. If not it will stop printing before the top and you will have to make the top few inches separately. I made this mistake and you can see the lines where glued it back together!!!

No supports needed. You can print on basic settings other than the pin which might need to be printed quite slow (About 50mm/s)

To assemble, line the lid up with the base and slide the pin through the holes of the edge of the base and the lid. You will need to glue the pin in with 3D printing glue or any strong glue. If you are confused you can use the picture for reference.