Thingiverse
Desktop lamp
door jimflc
19
Downloads
16
Likes
0
Makes
Desktop, bedside lamp, for standard LED strip, fits two sections.
Prints in two parts (base+arm).
There is an option without hole for switch.
A color change during the printing process gives a nice touch in my opinion.
0.2 layer height is good, but a change to 0.1 layer heigt for the top of the base will give a nicer curve transition.
Remember to add supports under the hole for the switch, if using simplify3D just manualy add support aroud the hole.
Support requierd for arm. (dosen't use that much)
Happy printing!
Prints in two parts (base+arm).
There is an option without hole for switch.
A color change during the printing process gives a nice touch in my opinion.
0.2 layer height is good, but a change to 0.1 layer heigt for the top of the base will give a nicer curve transition.
Remember to add supports under the hole for the switch, if using simplify3D just manualy add support aroud the hole.
Support requierd for arm. (dosen't use that much)
Happy printing!
jimflc publiceert ook op
3 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
