Thingiverse
Devil May Cry - Rebellion
por Bot_Force
3
Descargas
13
Likes
0
Makes
Most of this Rebellion mode was made by Fenixman12 and uploaded on Sketchfab. You can find the original unaltered model here: https://sketchfab.com/3d-models/rebellion-e8d8f8a73d0f4ff994c540c850a992b2
The Original rebellion model was more of an asset and wasn't 3D printable right off the bat, so I modified it to be fully 3D printable and assembleable, and also made a few teeny tiny modifications. I just sharpened the skull teeth to make them more demonic, and added a tiny bit more definition between them.
The total length of the sword as is 130cm (1300mm). There's a hole going all the way through the interior of the rebellion designed for a 115.8cm (1158mm) support rod of 1cm (10mm) thickness. If you want to go that route, you'll likely have to buy a bigger one and cut to size. Alternatively, I have also included a simple 3D printable a 15.8cm dowel insert as an option, so you'd only need a 100cm (1000mm) rod, which is a more common size. You'd shove it in and push it all the way to
The Original rebellion model was more of an asset and wasn't 3D printable right off the bat, so I modified it to be fully 3D printable and assembleable, and also made a few teeny tiny modifications. I just sharpened the skull teeth to make them more demonic, and added a tiny bit more definition between them.
The total length of the sword as is 130cm (1300mm). There's a hole going all the way through the interior of the rebellion designed for a 115.8cm (1158mm) support rod of 1cm (10mm) thickness. If you want to go that route, you'll likely have to buy a bigger one and cut to size. Alternatively, I have also included a simple 3D printable a 15.8cm dowel insert as an option, so you'd only need a 100cm (1000mm) rod, which is a more common size. You'd shove it in and push it all the way to
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
