Thingiverse
Dewalt bit holder
von tuxcomputers
9
Downloads
20
Likes
0
Makes
This bit holder screws on the side of a DeWalt drill, it was inspired by bit holder by plastirat.
Measurements were taken from the model by robertd33 and my DCD795 drill. I do not have access to a 3D printer right now so it is marked as in progress.
FreeCAD file is provided to make it easier to remix.
**UPDATE:** Turns out my bits are only 6.3mm and the model did not allow for alteration easily, version 2 comes with a spreadsheet to allow altering of parameters.
Measurements were taken from the model by robertd33 and my DCD795 drill. I do not have access to a 3D printer right now so it is marked as in progress.
FreeCAD file is provided to make it easier to remix.
**UPDATE:** Turns out my bits are only 6.3mm and the model did not allow for alteration easily, version 2 comes with a spreadsheet to allow altering of parameters.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
