Thingiverse
DeWalt Drill Guide
von jhoff
981
Downloads
733
Likes
0
Makes
This is a 3 post variation of Roukie68's drill guide using 8mm stainless steel rods. Fits my DeWalt DCD780 just fine and should work with a DCD777 among others as it uses the same dimensions as Roukie68's design.
Rod lengths are up to you. I used 3x 265mm rods but anything around that should be fine.
I used a 5/16" drill bit to drill out the base holes and a 21/64" bit to drill out the mount holes. Then I used a heat gun to warm up the ends of the rods and hammer them down into the base.
Fusion 360, SketchUp and STEP files are included.
Rod lengths are up to you. I used 3x 265mm rods but anything around that should be fine.
I used a 5/16" drill bit to drill out the base holes and a 21/64" bit to drill out the mount holes. Then I used a heat gun to warm up the ends of the rods and hammer them down into the base.
Fusion 360, SketchUp and STEP files are included.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
