Thingiverse
Dewalt DW735 Post Cap
door Frio
26
Downloads
10
Likes
2
Makes
A replacement cap for the posts on a Dewalt DW735 thickness planer. There are two versions:
- One is a close replica of the original part with a domed top. This one will require support in the center section.
- The other is slightly different than the original but prints without support. This one has a single layer bridge supporting the screw hole that can easily be cleared by drilled out or simply pushing the screw through. (Single layer bridge assumes a 0.2 layer height)
- One is a close replica of the original part with a domed top. This one will require support in the center section.
- The other is slightly different than the original but prints without support. This one has a single layer bridge supporting the screw hole that can easily be cleared by drilled out or simply pushing the screw through. (Single layer bridge assumes a 0.2 layer height)
Frio publiceert ook op
26 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
