Slicer Discord
DEWALT toolbox latch replacement – 3D-Druckmodell von Thingiverse Thingiverse

DEWALT toolbox latch replacement

von datapagan
3 Downloads
1 Likes
0 Makes
Zum Modell
Found a Dewalt toolbox from 2006 free to take at the side of the road, one of the latches were broken but apart from that it was in good condition for its age, I have made a quick replacement piece, I had to snip off the two "fingers" to install this, If you have the same design then you will understand.
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

datapagan veröffentlicht auch auf

35 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen