DeWalt Triple Bit Holder

Revised V2
Inside contour now follows tool feature more closely (more secure mounting)
Added additional finger for locking location
Revised screw hole for countersunk head (easier mounting, less cracking under strain)
Additional edge breaks to reduce sharp surfaces
--------------------------

I've seen a couple of bit holder projects here on thingiverse and haven't been satisfied with them. I thought I'd take a stab at creating one myself. I use a blend of phillips, square, and torx drive fasteners so a triple bit pod is ideal for my needs. This is version 1 of my attempt to create a helpful accessory that will attach with my drills and impact drivers.

Print on the angled face to avoid orthogonal layers and cracking when tightening the fastener and less support material in hex features.

You'll need a small machine screw to attach this. I'm not sure of sizing b/c I had a handful of small fasteners that fit but weren't labeled.

I haven't verified this will hold